Low and High Date range parameter in the concurrent program
The
concurrent program has 2 date parameter e.g. Start Date and End date.
The requirement is that start date should always be less than end date.
Solution:
1) In the concurrent program definition parameters, select Range as Low for Start Date. See Screenshot below
2) In the concurrent program definition parameters, select Range as high for End Date. See Screenshot below. Note that the value set being used for Start date and End date should be same.
3) Test program entering incorrect value for the parameter.
4) Test again by entering correct value.
Solution:
1) In the concurrent program definition parameters, select Range as Low for Start Date. See Screenshot below
2) In the concurrent program definition parameters, select Range as high for End Date. See Screenshot below. Note that the value set being used for Start date and End date should be same.
3) Test program entering incorrect value for the parameter.
4) Test again by entering correct value.
This is a great article.Good job Abhishek. Keep blogging.
ReplyDeleteThis is a great article.Good job Abhishek. Keep blogging.
ReplyDelete